Skip to content
EPCMap

How energy efficient are homes in CM1 3 (Chelmsford)?

Summary

Average rating

D66

CM1 average: C 70

Homes in CM1 3 have an average EPC rating of D (66), a little below the CM1 average of C (70).

Rated D or worse
50%
CM1: 40%
Typical yearly energy cost
£974
EPCs since 2021, at prices then
Built before 1930
13%

For landlords: 46% of privately rented homes here are below C (298 homes), the minimum from October 2030. See the 2030 rules

How ratings are spread

Share of homes in each band, with the score range for each. The dark line marks the CM1 average.

  • Band A, score 92 to 100: <1% of homes; CM1 <1%.
  • Band B, score 81 to 91: 7% of homes; CM1 22%.
  • Band C, score 69 to 80: 43% of homes; CM1 37%.
  • Band D, score 55 to 68: 33% of homes; CM1 30%.
  • Band E, score 39 to 54: 13% of homes; CM1 9%.
  • Band F, score 21 to 38: 3% of homes; CM1 2%.
  • Band G, score 1 to 20: <1% of homes; CM1 <1%.

Based on the latest energy performance certificate (EPC) for each of 2,652 homes, up to October 2026. EPCs rate homes from A (most efficient) to G (least), with a score out of 100. CM1 3 is a postcode sector: every postcode that starts CM1 3.

Other postcode sectors in CM1

CM1 3 is level with another sector for the lowest average rating of the 6 sectors in CM1 with enough EPCs to show.

What homes here are like

What EPC assessors recorded when they visited homes in CM1 3.

Main heating

Gas boiler71%
Electric storage heaters14%
Oil boiler7%
Other electric heating5%
Heat pump3%

Walls, roof and windows

Solid walls, not insulated17%
Cavity walls, not insulated15%
Cavity walls, insulated51%
Solid walls, insulated4%
Other walls (timber, system-built or modern)14%
Loft insulation under 100 mm (homes with a loft)17%
Double or triple glazing throughout89%
Solar panels1%

Ratings by type of home

Flats usually rate higher than houses because they lose less heat through shared walls, floors and ceilings.

Type of homeShare of homesAverage ratingRated D or worse
Detached house17%D 62CM1: D 6867%
Semi-detached house24%D 62CM1: D 6665%
Terraced house21%D 66CM1: D 6851%
Bungalow10%D 64CM1: D 6350%
Flat or maisonette28%C 71CM1: C 7527%

Typical floor area is the median. Types with fewer than 20 homes here aren't shown.

Privately rented homes and the 2030 standard

Landlords need an EPC rating of at least E to let a home today. From 1 October 2030, privately rented homes in England and Wales will need a C or better, unless the landlord registers an exemption.

46%

of privately rented homes here are below C (298 homes)

CM1: 50%

  • 93% of those could reach C with the upgrades listed on their EPC.
  • &lt;1% are rated F or G, below today's minimum of E (CM1: 1%).

From homes whose latest EPC was for a private let. A home sold or let differently since may be counted in the wrong group. The 2030 standard will be measured with new EPC metrics, so treat these figures as a guide. Landlord guidance on GOV.UK

Upgrades recommended for homes in CM1 3

Where CM1 3 differs from the rest of CM1. For every upgrade and its typical cost, see CM1.

  • Solid wall insulation (internal or external)

    On 22% of EPCs here (CM1: 14%). 17% of homes here have solid walls with no insulation.

    Typical cost: £4,000–£14,000

With all its recommended upgrades, 93% of homes here could reach a C rating or better.

On EPCs issued since 2021, making every recommended upgrade would cut the typical home's energy cost by about £127 a year, at the prices used when each EPC was issued.

Map of CM1 3 and nearby areas

How CM1 3 compares with the postcode sectors around it.

CM1 1, Chelmsford: C 76CM1 2, Chelmsford: D 68CM1 4, Chelmsford: D 66CM1 6, Chelmsford: C 73CM1 7, Chelmsford: D 67CM1 9: not enough EPCs to showCM11 1, Billericay: D 66CM12 0, Billericay: D 66CM13 1, Brentwood: D 65CM14 5, Brentwood: D 65CM15 0, Brentwood: D 65CM15 9, Brentwood: D 66CM2 0, Chelmsford: D 68CM2 5, Chelmsford: D 66CM2 6, Chelmsford: C 69CM2 7, Chelmsford: D 66CM2 8, Chelmsford: D 66CM2 9, Chelmsford: D 67CM22 7, Bishop'S Stortford: D 64CM3 1, Chelmsford: D 62CM3 2, Chelmsford: D 65CM3 3, Chelmsford: C 71CM3 4, Chelmsford: D 63CM3 8, Chelmsford: D 63CM4 0, Ingatestone: D 64CM4 9, Ingatestone: D 64CM5 0, Ongar: D 64CM5 9, Ongar: D 63CM6 1, Dunmow: C 70CM8 1, Witham: C 70CM98 1: not enough EPCs to showSS11 7, Wickford: C 70CM1 4D 66CM1 7D 67CM15 0D 65CM2 6C 69CM2 7D 66CM2 8D 66CM2 9D 67CM4 0D 64CM4 9D 64CM1 3D 66CM1 2D 68CM1 4D 66CM1 6C 73CM15 0D 65CM2 0D 68CM2 6C 69CM2 7D 66CM2 8D 66CM3 3C 71CM4 0D 64CM4 9D 64CM1 3D 66
Colour shows each area's average rating. Tap an area to open it. A 92–100 B 81–91 C 69–80 D 55–68 E 39–54 F 21–38 G 1–20 CM1 3 Not enough EPCs

Bordering postcode sectors

Common questions

What holds energy ratings back in CM1 3?

Older homes, uninsulated walls and lofts, and electric or oil heating all pull ratings down.

What is a postcode sector?

A postcode sector is the part of a postcode before the last two letters. CM1 3 covers every postcode that starts CM1 3, usually a few thousand homes. It's part of the CM1 postcode district.

Can I see the rating for my own home?

Yes. Individual certificates are on the official EPC Register on GOV.UK. EPCMap only shows figures for whole areas.