Skip to content
EPCMap

How energy efficient are homes in HP10 8 (High Wycombe, Buckinghamshire)?

Summary

Average rating

D65

HP10 average: D 67

Homes in HP10 8 have an average EPC rating of D (65), a little below the HP10 average of D (67).

Rated D or worse
59%
HP10: 50%
Typical yearly energy cost
£1,470
EPCs since 2021, at prices then
Built before 1930
13%

For landlords: 58% of privately rented homes here are below C (91 homes), the minimum from October 2030. See the 2030 rules

How ratings are spread

Share of homes in each band, with the score range for each. The dark line marks the HP10 average.

  • Band A, score 92 to 100: <1% of homes; HP10 <1%.
  • Band B, score 81 to 91: 7% of homes; HP10 13%.
  • Band C, score 69 to 80: 33% of homes; HP10 36%.
  • Band D, score 55 to 68: 43% of homes; HP10 37%.
  • Band E, score 39 to 54: 14% of homes; HP10 11%.
  • Band F, score 21 to 38: 2% of homes; HP10 2%.
  • Band G, score 1 to 20: <1% of homes; HP10 <1%.

Based on the latest energy performance certificate (EPC) for each of 1,428 homes, up to October 2026. EPCs rate homes from A (most efficient) to G (least), with a score out of 100. HP10 8 is a postcode sector: every postcode that starts HP10 8.

Other postcode sectors in HP10

HP10 8 has the lowest average rating of the 3 sectors in HP10 with enough EPCs to show.

What homes here are like

What EPC assessors recorded when they visited homes in HP10 8.

Main heating

Gas boiler90%
Heat pump3%
Other electric heating2%
Other or unrecorded2%
Electric storage heaters2%
Oil boiler1%

Walls, roof and windows

Solid walls, not insulated12%
Cavity walls, not insulated26%
Cavity walls, insulated51%
Other walls (timber, system-built or modern)10%
Loft insulation under 100 mm (homes with a loft)22%
Double or triple glazing throughout86%
Solar panels1%

Ratings by type of home

Flats usually rate higher than houses because they lose less heat through shared walls, floors and ceilings.

Type of homeShare of homesAverage ratingRated D or worse
Detached house52%D 64HP10: D 6561%
Semi-detached house21%D 65HP10: D 6562%
Terraced house9%D 67HP10: C 6954%
Bungalow10%D 64HP10: D 6262%
Flat or maisonette8%D 66HP10: C 7348%

Typical floor area is the median. Types with fewer than 20 homes here aren't shown.

Privately rented homes and the 2030 standard

Landlords need an EPC rating of at least E to let a home today. From 1 October 2030, privately rented homes in England and Wales will need a C or better, unless the landlord registers an exemption.

58%

of privately rented homes here are below C (91 homes)

HP10: 56%

  • 98% of those could reach C with the upgrades listed on their EPC.
  • 0% are rated F or G, below today's minimum of E (HP10: 1%).

From homes whose latest EPC was for a private let. A home sold or let differently since may be counted in the wrong group. The 2030 standard will be measured with new EPC metrics, so treat these figures as a guide. Landlord guidance on GOV.UK

Upgrades recommended for homes in HP10 8

Where HP10 8 differs from the rest of HP10. For every upgrade and its typical cost, see HP10.

  • Cavity wall insulation

    On 29% of EPCs here (HP10: 22%). 26% of homes here have unfilled cavity walls.

    Typical cost: £500–£1,500
  • Loft insulation top-up

    On 24% of EPCs here (HP10: 18%). 22% of homes with a loft have less than 100 mm of insulation.

    Typical cost: £100–£350

With all its recommended upgrades, 92% of homes here could reach a C rating or better.

On EPCs issued since 2021, making every recommended upgrade would cut the typical home's energy cost by about £185 a year, at the prices used when each EPC was issued.

Map of HP10 8 and nearby areas

How HP10 8 compares with the postcode sectors around it.

HP10 0, High Wycombe: D 66HP10 9, High Wycombe: C 69HP11 1, High Wycombe: C 72HP11 2, High Wycombe: C 69HP12 3, High Wycombe: D 67HP12 4, High Wycombe: D 66HP13 5, High Wycombe: C 69HP13 6, High Wycombe: D 66HP13 7, High Wycombe: C 69HP14 3, High Wycombe: D 64HP14 4, High Wycombe: D 64HP15 6, High Wycombe: D 65HP15 7, High Wycombe: D 66HP16 0, Great Missenden: D 64HP27 0, Princes Risborough: D 65HP5 1, Chesham: D 66HP6 5, Amersham: D 66HP6 6, Amersham: D 67HP7 0, Amersham: D 64HP7 9, Amersham: D 67HP8 4, Chalfont St. Giles: D 65HP9 1, Beaconsfield: D 68HP9 2, Beaconsfield: D 68SL2 3, Slough: D 66SL7 1, Marlow: D 66SL7 2, Marlow: D 64SL7 3, Marlow: D 66SL8 5, Bourne End: D 65SL9 8, Gerrards Cross: D 68HP10 0D 66HP10 9C 69HP11 1C 72HP13 5C 69HP15 6D 65HP15 7D 66HP7 0D 64HP9 1D 68HP9 2D 68HP10 8D 65HP10 0D 66HP10 9C 69HP11 1C 72HP11 2C 69HP13 5C 69HP13 6D 66HP15 6D 65HP15 7D 66HP7 0D 64HP9 1D 68HP9 2D 68SL7 3D 66HP10 8D 65
Colour shows each area's average rating. Tap an area to open it. A 92–100 B 81–91 C 69–80 D 55–68 E 39–54 F 21–38 G 1–20 HP10 8 Not enough EPCs

Bordering postcode sectors

Common questions

What holds energy ratings back in HP10 8?

Older homes, uninsulated walls and lofts, and electric or oil heating all pull ratings down.

What is a postcode sector?

A postcode sector is the part of a postcode before the last two letters. HP10 8 covers every postcode that starts HP10 8, usually a few thousand homes. It's part of the HP10 postcode district.

Can I see the rating for my own home?

Yes. Individual certificates are on the official EPC Register on GOV.UK. EPCMap only shows figures for whole areas.