Skip to content
EPCMap

How energy efficient are homes in SE2 0 (London, Greenwich)?

Summary

Average rating

D65

SE2 average: C 69

Homes in SE2 0 have an average EPC rating of D (65), a little below the SE2 average of C (69). 65% of homes here have solid walls with no insulation.

Rated D or worse
61%
SE2: 47%
Typical yearly energy cost
£1,032
EPCs since 2021, at prices then
Built before 1930
36%

For landlords: 59% of privately rented homes here are below C (711 homes), the minimum from October 2030. See the 2030 rules

How ratings are spread

Share of homes in each band, with the score range for each. The dark line marks the SE2 average.

  • Band A, score 92 to 100: <1% of homes; SE2 <1%.
  • Band B, score 81 to 91: 3% of homes; SE2 17%.
  • Band C, score 69 to 80: 35% of homes; SE2 35%.
  • Band D, score 55 to 68: 47% of homes; SE2 37%.
  • Band E, score 39 to 54: 12% of homes; SE2 9%.
  • Band F, score 21 to 38: 1% of homes; SE2 <1%.
  • Band G, score 1 to 20: <1% of homes; SE2 <1%.

Based on the latest energy performance certificate (EPC) for each of 3,318 homes, up to October 2026. EPCs rate homes from A (most efficient) to G (least), with a score out of 100. SE2 0 is a postcode sector: every postcode that starts SE2 0.

Other postcode sectors in SE2

SE2 0 has the lowest average rating of the 2 sectors in SE2 with enough EPCs to show.

What homes here are like

What EPC assessors recorded when they visited homes in SE2 0.

Main heating

Gas boiler92%
Other electric heating3%
Electric storage heaters3%

Walls, roof and windows

Solid walls, not insulated65%
Cavity walls, not insulated12%
Cavity walls, insulated17%
Solid walls, insulated2%
Other walls (timber, system-built or modern)4%
Loft insulation under 100 mm (homes with a loft)39%
Double or triple glazing throughout91%

Ratings by type of home

Flats usually rate higher than houses because they lose less heat through shared walls, floors and ceilings.

Type of homeShare of homesAverage ratingRated D or worse
Detached house2%D 57SE2: D 5878%
Semi-detached house11%D 60SE2: D 6184%
Terraced house51%D 63SE2: D 6572%
Bungalow1%D 56SE2: D 6187%
Flat or maisonette35%C 70SE2: C 7335%

Typical floor area is the median. Types with fewer than 20 homes here aren't shown.

Privately rented homes and the 2030 standard

Landlords need an EPC rating of at least E to let a home today. From 1 October 2030, privately rented homes in England and Wales will need a C or better, unless the landlord registers an exemption.

59%

of privately rented homes here are below C (711 homes)

SE2: 52%

  • 94% of those could reach C with the upgrades listed on their EPC.
  • &lt;1% are rated F or G, below today's minimum of E (SE2: <1%).

From homes whose latest EPC was for a private let. A home sold or let differently since may be counted in the wrong group. The 2030 standard will be measured with new EPC metrics, so treat these figures as a guide. Landlord guidance on GOV.UK

Upgrades recommended for homes in SE2 0

Where SE2 0 differs from the rest of SE2. For every upgrade and its typical cost, see SE2.

  • Solid wall insulation (internal or external)

    On 67% of EPCs here (SE2: 32%). 65% of homes here have solid walls with no insulation.

    Typical cost: £4,000–£14,000
  • Floor insulation

    On 55% of EPCs here (SE2: 38%).

    Typical cost: £4,000–£6,000
  • Solar panels (PV)

    On 63% of EPCs here (SE2: 48%).

    Typical cost: £5,000–£8,000
  • Solar water heating

    On 53% of EPCs here (SE2: 42%).

    Typical cost: £4,000–£6,000
  • Hot water cylinder insulation

    On 5% of EPCs here (SE2: 13%).

    Typical cost: £15–£30

With all its recommended upgrades, 91% of homes here could reach a C rating or better.

On EPCs issued since 2021, making every recommended upgrade would cut the typical home's energy cost by about £238 a year, at the prices used when each EPC was issued.

Map of SE2 0 and nearby areas

How SE2 0 compares with the postcode sectors around it.

DA16 1, Welling: D 63DA16 2, Welling: D 60DA16 3, Welling: D 64DA17 5, Belvedere: D 65DA17 6, Belvedere: D 68DA18 4, Erith: D 66DA6 7, Bexleyheath: C 71DA7 4, Bexleyheath: D 63DA7 5, Bexleyheath: D 60DA7 6, Bexleyheath: D 63DA8 1, Erith: C 70DA8 3, Erith: D 68E16 2, London: B 81SE18 1, London: D 65SE18 2, London: D 65SE18 3, London: D 66SE18 6, London: C 79SE18 7, London: C 69SE2 9, London: C 71SE28 0, London: C 78SE28 8, London: C 71SE9 1, London: D 60SE9 2, London: D 66DA16 1D 63DA16 3D 64DA17 5D 65DA17 6D 68DA18 4D 66DA7 4D 63DA7 5D 60SE18 1D 65SE18 2D 65SE2 9C 71SE28 0C 78SE2 0D 65DA16 1D 63DA16 3D 64DA17 5D 65DA17 6D 68DA18 4D 66DA7 4D 63DA7 5D 60SE18 1D 65SE18 2D 65SE2 9C 71SE28 0C 78SE2 0D 65
Colour shows each area's average rating. Tap an area to open it. A 92–100 B 81–91 C 69–80 D 55–68 E 39–54 F 21–38 G 1–20 SE2 0 Not enough EPCs

Bordering postcode sectors

Common questions

What holds energy ratings back in SE2 0?

About 65% of homes here have solid walls with no insulation, which lose much more heat than insulated walls. 36% were built before 1930. Older homes, uninsulated walls and lofts, and electric or oil heating all pull ratings down.

What is a postcode sector?

A postcode sector is the part of a postcode before the last two letters. SE2 0 covers every postcode that starts SE2 0, usually a few thousand homes. It's part of the SE2 postcode district.

Can I see the rating for my own home?

Yes. Individual certificates are on the official EPC Register on GOV.UK. EPCMap only shows figures for whole areas.