Skip to content
EPCMap

How energy efficient are homes in GL2 0 (Gloucester)?

Summary

Average rating

D64

GL2 average: C 71

Homes in GL2 0 have an average EPC rating of D (64), well below the GL2 average of C (71).

Rated D or worse
66%
GL2: 37%
Typical yearly energy cost
£1,191
EPCs since 2021, at prices then
Built before 1930
10%

For landlords: 49% of privately rented homes here are below C (424 homes), the minimum from October 2030. See the 2030 rules

How ratings are spread

Share of homes in each band, with the score range for each. The dark line marks the GL2 average.

  • Band A, score 92 to 100: <1% of homes; GL2 2%.
  • Band B, score 81 to 91: 4% of homes; GL2 26%.
  • Band C, score 69 to 80: 31% of homes; GL2 35%.
  • Band D, score 55 to 68: 50% of homes; GL2 27%.
  • Band E, score 39 to 54: 14% of homes; GL2 8%.
  • Band F, score 21 to 38: 2% of homes; GL2 2%.
  • Band G, score 1 to 20: <1% of homes; GL2 <1%.

Based on the latest energy performance certificate (EPC) for each of 3,175 homes, up to October 2026. EPCs rate homes from A (most efficient) to G (least), with a score out of 100. GL2 0 is a postcode sector: every postcode that starts GL2 0.

Other postcode sectors in GL2

GL2 0 has the 5th highest average rating of the 8 sectors in GL2 with enough EPCs to show.

What homes here are like

What EPC assessors recorded when they visited homes in GL2 0.

Main heating

Gas boiler91%
Electric storage heaters4%
Other electric heating3%

Walls, roof and windows

Solid walls, not insulated6%
Cavity walls, not insulated24%
Cavity walls, insulated58%
Other walls (timber, system-built or modern)12%
Loft insulation under 100 mm (homes with a loft)17%
Double or triple glazing throughout91%
Solar panels1%

Ratings by type of home

Flats usually rate higher than houses because they lose less heat through shared walls, floors and ceilings.

Type of homeShare of homesAverage ratingRated D or worse
Detached house18%D 64GL2: C 7165%
Semi-detached house50%D 62GL2: C 7074%
Terraced house15%D 67GL2: C 7349%
Bungalow8%D 63GL2: D 6373%
Flat or maisonette9%D 68GL2: C 7445%

Typical floor area is the median. Types with fewer than 20 homes here aren't shown.

Privately rented homes and the 2030 standard

Landlords need an EPC rating of at least E to let a home today. From 1 October 2030, privately rented homes in England and Wales will need a C or better, unless the landlord registers an exemption.

49%

of privately rented homes here are below C (424 homes)

GL2: 41%

  • 99% of those could reach C with the upgrades listed on their EPC.
  • 0% are rated F or G, below today's minimum of E (GL2: <1%).

From homes whose latest EPC was for a private let. A home sold or let differently since may be counted in the wrong group. The 2030 standard will be measured with new EPC metrics, so treat these figures as a guide. Landlord guidance on GOV.UK

Upgrades recommended for homes in GL2 0

Where GL2 0 differs from the rest of GL2. For every upgrade and its typical cost, see GL2.

  • Floor insulation

    On 70% of EPCs here (GL2: 41%).

    Typical cost: £4,000–£6,000
  • Cavity wall insulation

    On 26% of EPCs here (GL2: 12%). 24% of homes here have unfilled cavity walls.

    Typical cost: £500–£1,500
  • New condensing boiler

    On 31% of EPCs here (GL2: 20%).

    Typical cost: £2,200–£3,000
  • Heating controls

    On 24% of EPCs here (GL2: 14%).

    Typical cost: £350–£450
  • Loft insulation top-up

    On 20% of EPCs here (GL2: 12%). 17% of homes with a loft have less than 100 mm of insulation.

    Typical cost: £100–£350

With all its recommended upgrades, 95% of homes here could reach a C rating or better.

On EPCs issued since 2021, making every recommended upgrade would cut the typical home's energy cost by about £173 a year, at the prices used when each EPC was issued.

Map of GL2 0 and nearby areas

How GL2 0 compares with the postcode sectors around it.

GL1 1, Gloucester: D 67GL1 2, Gloucester: C 71GL1 3, Gloucester: D 67GL1 4, Gloucester: D 62GL1 5, Gloucester: D 64GL2 5, Gloucester: C 74GL2 8, Gloucester: D 63GL2 9, Gloucester: C 73GL3 1, Gloucester: C 76GL3 2, Gloucester: D 64GL3 3, Gloucester: D 65GL3 4, Gloucester: C 75GL4 3, Gloucester: D 67GL4 4, Gloucester: D 68GL4 5, Gloucester: D 67GL4 6, Gloucester: C 70GL4 8, Gloucester: D 59GL51 0, Cheltenham: C 70GL51 6, Cheltenham: D 67GL1 1D 67GL1 2C 71GL1 3D 67GL1 4D 62GL1 5D 64GL3 1C 76GL3 2D 64GL3 3D 65GL4 3D 67GL2 0D 64GL1 1D 67GL1 2C 71GL1 3D 67GL1 4D 62GL1 5D 64GL3 1C 76GL3 2D 64GL3 3D 65GL4 3D 67GL2 0D 64
Colour shows each area's average rating. Tap an area to open it. A 92–100 B 81–91 C 69–80 D 55–68 E 39–54 F 21–38 G 1–20 GL2 0 Not enough EPCs

Bordering postcode sectors

Common questions

What holds energy ratings back in GL2 0?

Older homes, uninsulated walls and lofts, and electric or oil heating all pull ratings down.

What is a postcode sector?

A postcode sector is the part of a postcode before the last two letters. GL2 0 covers every postcode that starts GL2 0, usually a few thousand homes. It's part of the GL2 postcode district.

Can I see the rating for my own home?

Yes. Individual certificates are on the official EPC Register on GOV.UK. EPCMap only shows figures for whole areas.