Skip to content
EPCMap

How energy efficient are homes in BA2 0 (Bath)?

Summary

Average rating

D64

BA2 average: D 66

Homes in BA2 0 have an average EPC rating of D (64), a little below the BA2 average of D (66).

Rated D or worse
58%
BA2: 53%
Typical yearly energy cost
£1,198
EPCs since 2021, at prices then
Built before 1930
23%

For landlords: 58% of privately rented homes here are below C (132 homes), the minimum from October 2030. See the 2030 rules

How ratings are spread

Share of homes in each band, with the score range for each. The dark line marks the BA2 average.

  • Band A, score 92 to 100: 1% of homes; BA2 <1%.
  • Band B, score 81 to 91: 10% of homes; BA2 12%.
  • Band C, score 69 to 80: 31% of homes; BA2 34%.
  • Band D, score 55 to 68: 37% of homes; BA2 37%.
  • Band E, score 39 to 54: 16% of homes; BA2 13%.
  • Band F, score 21 to 38: 5% of homes; BA2 3%.
  • Band G, score 1 to 20: 1% of homes; BA2 <1%.

Based on the latest energy performance certificate (EPC) for each of 1,531 homes, up to October 2026. EPCs rate homes from A (most efficient) to G (least), with a score out of 100. BA2 0 is a postcode sector: every postcode that starts BA2 0.

Other postcode sectors in BA2

BA2 0 is level with another sector for the 5th highest average rating of the 10 sectors in BA2 with enough EPCs to show.

What homes here are like

What EPC assessors recorded when they visited homes in BA2 0.

Main heating

Gas boiler74%
Oil boiler17%
Electric storage heaters4%
Heat pump3%
Other electric heating2%

Walls, roof and windows

Solid walls, not insulated22%
Cavity walls, not insulated16%
Cavity walls, insulated46%
Solid walls, insulated2%
Other walls (timber, system-built or modern)14%
Loft insulation under 100 mm (homes with a loft)15%
Double or triple glazing throughout90%
Solar panels2%

Ratings by type of home

Flats usually rate higher than houses because they lose less heat through shared walls, floors and ceilings.

Type of homeShare of homesAverage ratingRated D or worse
Detached house24%D 63BA2: D 6263%
Semi-detached house28%D 63BA2: D 6364%
Terraced house21%D 64BA2: D 6554%
Bungalow20%D 63BA2: D 6359%
Flat or maisonette7%C 71BA2: C 7029%

Typical floor area is the median. Types with fewer than 20 homes here aren't shown.

Privately rented homes and the 2030 standard

Landlords need an EPC rating of at least E to let a home today. From 1 October 2030, privately rented homes in England and Wales will need a C or better, unless the landlord registers an exemption.

58%

of privately rented homes here are below C (132 homes)

BA2: 59%

  • 94% of those could reach C with the upgrades listed on their EPC.
  • 2% are rated F or G, below today's minimum of E (BA2: 1%).

From homes whose latest EPC was for a private let. A home sold or let differently since may be counted in the wrong group. The 2030 standard will be measured with new EPC metrics, so treat these figures as a guide. Landlord guidance on GOV.UK

Upgrades recommended for homes in BA2 0

Where BA2 0 differs from the rest of BA2. For every upgrade and its typical cost, see BA2.

  • Solar water heating

    On 75% of EPCs here (BA2: 56%).

    Typical cost: £4,000–£6,000
  • Floor insulation

    On 63% of EPCs here (BA2: 50%).

    Typical cost: £4,000–£6,000
  • Solid wall insulation (internal or external)

    On 25% of EPCs here (BA2: 32%). 22% of homes here have solid walls with no insulation.

    Typical cost: £4,000–£14,000
  • Double glazing

    On 10% of EPCs here (BA2: 16%). 10% of homes aren't fully double or triple glazed.

    Typical cost: £3,300–£6,500
  • Cavity wall insulation

    On 20% of EPCs here (BA2: 15%). 16% of homes here have unfilled cavity walls.

    Typical cost: £500–£1,500

With all its recommended upgrades, 90% of homes here could reach a C rating or better.

On EPCs issued since 2021, making every recommended upgrade would cut the typical home's energy cost by about £216 a year, at the prices used when each EPC was issued.

Map of BA2 0 and nearby areas

How BA2 0 compares with the postcode sectors around it.

BA1 1, Bath: D 64BA1 2, Bath: D 63BA1 3, Bath: D 64BA1 5, Bath: D 63BA1 8, Bath: D 61BA11 2, Frome: D 65BA2 1, Bath: D 67BA2 2, Bath: D 67BA2 3, Bath: C 69BA2 4, Bath: D 61BA2 5, Bath: C 70BA2 6, Bath: D 64BA2 7, Bath: D 61BA2 8, Bath: D 63BA2 9, Bath: D 57BA3 2, Radstock: D 66BA3 3, Radstock: D 67BA3 4, Radstock: D 68BA3 5, Radstock: D 62BA5 3, Wells: D 62BS14 0, Bristol: C 71BS31 2, Bristol: C 72BS39 4, Bristol: D 55BS39 5, Bristol: D 66BS39 6, Bristol: D 63BS39 7, Bristol: D 68BS40 6, Bristol: D 60BS40 8, Bristol: D 62BS41 8, Bristol: D 60BA2 1D 67BA2 2D 67BA2 8D 63BA2 9D 57BA3 2D 66BS39 4D 55BS39 5D 66BS39 6D 63BA2 0D 64BA2 1D 67BA2 2D 67BA2 3C 69BA2 8D 63BA2 9D 57BA3 2D 66BA3 3D 67BS39 4D 55BS39 5D 66BS39 6D 63BS39 7D 68BA2 0D 64
Colour shows each area's average rating. Tap an area to open it. A 92–100 B 81–91 C 69–80 D 55–68 E 39–54 F 21–38 G 1–20 BA2 0 Not enough EPCs

Bordering postcode sectors

Common questions

What holds energy ratings back in BA2 0?

Older homes, uninsulated walls and lofts, and electric or oil heating all pull ratings down.

What is a postcode sector?

A postcode sector is the part of a postcode before the last two letters. BA2 0 covers every postcode that starts BA2 0, usually a few thousand homes. It's part of the BA2 postcode district.

Can I see the rating for my own home?

Yes. Individual certificates are on the official EPC Register on GOV.UK. EPCMap only shows figures for whole areas.